
VirtualReScan (VRS) User’s Guide 119
Appendix A
Scanner Configuration Utility
Introduction
You can use the Kofax Scanner Configuration Utility to create and configure scan and
image device sources, and set VRS default scanners. The Scanner Configuration
Utility is available from the Kofax VRS program folder.
From your scanning application, you select a scan source to ensure that the
appropriate drivers are used during your scanning session. As explained earlier in
this guide, a VRS scan source must be selected in order to run VRS with your
scanning application.
If you have installed either VRS or an Adrenaline SCSI scanner controller and selected
a scanner, several preconfigured scan sources are already available for use with your
scanning application. Scan sources are also available if you have installed a VRS
Component Installer. Therefore, in most cases, you will not need to use the Scanner
Configuration Utility to create a scan source.
You may need to use the utility to create an additional scan source if one of the
following situations is applicable to your installation:
You are using VRS with a “compatible” scanner, which is a scanner that has
not gone through the VRS certification process.
You are using a Kofax Adrenaline SCSI scanner controller (without VRS) with a
“compatible” scanner, and you want to create a source other than the default
source named “<XYZ Scanner> without SVRS.”
Using the Scanner Configuration Utility, you can do the following:
Create and configure scan sources
Select a scanner and set it as the VRS default scanner
Restore the VRS default settings for a specific scanner
Set source properties
Create and manage import sources
Comentarios a estos manuales